Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Flatbush Homeowners
Leaky ducts waste the air you’re already paying to heat and cool, and in Flatbush’s older apartment stock that loss is often worse than it looks. Duct repair and sealing closes those gaps at the source: we find where the system is losing air, repair the duct run, and seal it so the supply air lands in the rooms it’s meant for. The work is done by technicians with up to 14 years of experience using purpose-built extraction and containment equipment, not improvised tools. Same-day appointments are often available. Call (866) 937-8518. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The local pro is licensed and insured as their state requires, and you get one flat price per system agreed before work starts, along with before-and-after photos of your own ducts.
What Our Duct Repair & Sealing Service Includes
Duct repair and sealing is the part of a full-system job most cleaners skip. Wiping vents is easy. Finding the disconnected flex run behind a soffit in a prewar building on Ocean Avenue, or the crushed trunk line above a drop ceiling, takes a specialist. Here’s what each part of the service covers.
Duct Sealing
Sealing means closing the joints, seams, and penetrations where conditioned air escapes into a wall cavity or attic instead of reaching a bedroom. You need it when rooms never quite get warm in winter or cool in summer no matter how the registers feel at the vent itself. We locate the leaks with airflow diagnostics, then seal them so the whole system holds pressure the way it was designed to.

Flex Duct Repair
Flex duct is the corrugated silver tubing common in newer conversions and above-ceiling runs, and it’s easy to crush, kink, or tear. A single crushed section can cut airflow to an entire room while the rest of the system looks fine. We repair or replace damaged sections, re-stretch runs that sag, and reconnect the ends so the air has a clear path.

Metal Duct Repair
Sheet metal ductwork in Flatbush’s older buildings develops separated seams, popped joints, and rust-through at low points where moisture collects. Those gaps leak air quietly and, in a basement run, pull in dust from the surrounding space. We repair the section, reseal the seams, and check the surrounding run for the same failure before it spreads.

Duct Insulation
Bare or degraded duct insulation lets conditioned air lose its temperature before it reaches the room, which is why some ducts sweat in summer and feel cool to the touch in winter. We assess the wrap on the runs we can reach and restore insulation where it has sagged, torn, or gone missing. This is the step that keeps the air you’ve paid to cool from warming up on the way to the bedroom.
Mastic Sealant
Mastic is a brush-applied sealant that bonds to metal and stays flexible as the ductwork expands and contracts through the year. Tape alone often dries out and peels within a season, which is why we use mastic on seams and joints. We apply it cleanly so the seal lasts, and we don’t leave adhesive smeared across the inside of the duct where it could catch debris.
Air Leak Repair
There are leaks you can see and leaks that only show up on airflow measurements, and the invisible ones usually cost the most. Air leaking out of a return in a mechanical closet pulls dust straight into the system; air leaking from a supply line dumps heated or cooled air into a wall. We trace those leaks and repair them so the system stops paying for air it never delivers.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
Ductwork doesn’t carry a brand the way a furnace does, but the equipment attached to it does, and sealing decisions have to account for how that equipment is configured. We work with Honeywell and Aprilaire air-quality products, which means we can assess filtration and humidity control alongside the repair instead of sealing a system that will keep fighting the same dust problems. When a filter cabinet or in-line humidifier has been added to the return, the connections around it are a common leak point, and sealing them properly takes knowing how the housing was meant to sit.
On the extraction side, we use Rotobrush and Nikro systems built specifically for duct interiors, along with Abatement Technologies negative-air containment so dislodged debris doesn’t recirculate into your living space while we work. Whether your system has one of those air-quality products installed or any other make, we can help.
Signs You Need Duct Repair & Sealing Right Now
- Dust settles back within a day or two of cleaning. If your returns and surfaces are dusty again almost immediately, the system is likely pulling air from a dirty cavity through a failed seam. Sealing the leak stops the source instead of chasing the dust.
- One room never heats or cools like the rest. A single stubborn room usually points to a crushed flex run or a disconnected supply, not a weak furnace. That’s a duct problem and it’s fixable without replacing equipment.
- Your energy bill climbed without a change in how you use the house. Losing a share of your conditioned air into a wall is invisible on the bill, but it shows up. Sealing the system means the same runtime delivers more air to the rooms.
- Ducts whistle, rattle, or feel loose at the joint. Noise at a seam is moving air escaping under pressure. It’s an easy fix that gets harder the longer the joint is left to widen.
- You see condensation or staining near a duct run. Moisture on or near ductwork points to an insulation or seal failure that needs attention before it damages the surrounding building materials.
Our Duct Repair & Sealing Process – Step by Step
- 1
System inspection and airflow check. We walk the accessible duct runs and measure airflow at the registers to see which rooms are starved and where the pressure is dropping. This tells us where to look before we start opening anything.
- 2
Leak detection and mapping. Using visual inspection plus pressure readings, we trace where the air is escaping and note each leak by location. You get a clear picture of the problem, not a vague estimate.
- 3
Repair of damaged duct sections. Crushed flex, separated metal seams, and disconnected runs are repaired or replaced first. Sealing a duct that’s already structurally failing just hides the problem.
- 4
Sealing with mastic and re-insulating. We seal the joints and seams with mastic, then restore insulation where it’s been compromised. Any debris loosened during the work is contained with negative-air equipment so it doesn’t end up in your rooms.
- 5
Verification and before-and-after photos. We re-check airflow at the registers and show you photos of the work so you can see what changed. If the numbers don’t improve, the job isn’t done.
If the inspection turns up heavy buildup inside the runs, we’ll recommend air duct cleaning in Flatbush before sealing, since sealing over a dirty system locks the debris in place. For homeowners in the neighborhoods just east and south, the same service is available as duct repair & sealing in East Flatbush, and we cover the surrounding blocks through our duct repair & sealing work in Kensington. The equipment matters here: purpose-built Rotobrush and Nikro systems reach inside the duct, and Abatement Technologies containment keeps the dust out of your living space while we work.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Flatbush?
Duct repair and sealing in Flatbush typically runs $350 to $1,200 depending on how much of the system needs work, and a simple mastic reseal of a few accessible joints sits at the low end while a full re-insulation with multiple flex replacements lands higher. A typical air leak repair for one or two problem runs runs $250 to $500. Replacing a crushed flex duct section usually costs $200 to $450 per run. Restoring duct insulation on accessible runs is typically $300 to $700, and a broader mastic sealant job across the whole accessible system runs $400 to $900. The written estimate sets the final price, and the estimate itself is free.
What moves the number is access, not parts. Ductwork hidden above a hard ceiling or buried behind finished walls takes more time to reach than a basement run you can walk up to. The number of separate leaks, the condition of the existing insulation, and whether flex or metal is involved all factor in. The way to avoid overpaying is to get the leaks mapped before anyone quotes a price, so you’re paying for the actual repair rather than a flat allowance that may not cover your system. Every estimate we give includes the leak locations we found, the repair method, the sealing materials, and the before-and-after verification, with one flat price per system agreed before work starts.
Duct Repair & Sealing Near Flatbush – Our Service Area
We serve Flatbush and the surrounding neighborhoods, including Flatlands, Midwood, Crown Heights, Prospect Heights, Park Slope, Brownsville, Marine Park, Mill Basin, and Borough Park. Response times depend on where you are and how the day is booked, but most Flatbush calls get a same-day slot when you call early. If you’re near the Kensington line, the work is covered under our Kensington service area, and East Flatbush homeowners get the same team and the same process. Call (866) 937-8518 and we’ll confirm the soonest opening. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Serving Flatbush, NY – Our Local Coverage Area
We serve Flatbush and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Flatbush
Duct repair and sealing is the process of fixing damaged duct sections and closing the gaps where conditioned air escapes before it reaches your rooms. It covers crushed flex runs, separated metal seams, disconnected joints, failed insulation, and the small leaks that add up across a whole system. It’s different from cleaning, which removes buildup, and different from a filter change, which only addresses what enters the system. Repair and sealing fix the system’s ability to deliver air where it’s supposed to go.
Most residential jobs take two to four hours, though a system with multiple crushed runs or extensive insulation work can run longer. The inspection and leak mapping usually take under an hour, and we tell you the expected timeline before we start. If the work turns out to be bigger than the estimate suggested, we stop and talk to you before continuing. Call (866) 937-8518 for an exact timeline on your system.
Typical Flatbush jobs run $350 to $1,200, with a single air leak repair at $250 to $500 and a full-system mastic seal at $400 to $900. Flex duct replacement runs $200 to $450 per run, and insulation restoration is typically $300 to $700. What pushes the price up is access and the number of leaks, not the materials. Call (866) 937-8518 for an exact quote. Estimates are free, and the written estimate sets the final price.
A very low quote usually means the work is scoped to what’s visible from the vent, not to the actual leaks in the system. Sealing a couple of joints and calling it done leaves the crushed run and the disconnected supply untouched, and the dust and the high bill come right back. We map the leaks first and price the repair to the map, with one flat price per system agreed before work starts. Call (866) 937-8518 for a quote you can compare line by line.
Yes. We work with Honeywell and Aprilaire air-quality products, and we assess filtration and humidity control as part of the repair so the sealed system isn’t fighting a filter problem. When a filter cabinet or in-line humidifier has been added to the return, the connections around it are a common leak point, and we seal them properly. Call (866) 937-8518 to book an assessment.
Same-day appointments are often available in Flatbush, especially when you call earlier in the day. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. There’s no surcharge for same-day work; the price is set per job by the written estimate. Call (866) 937-8518 to check availability.
Clear access to your registers and to any mechanical closet or basement where the ductwork runs, and move anything fragile away from the work area. If you have pets, keep them in a room away from the work zone while we’re there. You don’t need to do anything else; we bring the containment equipment and handle cleanup. Call (866) 937-8518 if you’re unsure what to move.
Schedule Your Duct Repair & Sealing Service in Flatbush Today
Leaky ducts cost you every month the system runs, and the fix is usually smaller than homeowners expect. Call (866) 937-8518 for a free, no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. You’ll get a flat price per system agreed before work starts and before-and-after photos of your own ducts. Same-day appointments are often available in Flatbush.
Written by the team at Air Duct Cleaning Flatbush.